.png)
There are 9 products.
Active filters
Differential Pressure Transmitter DMG5
Kalinsky differential pressure gauge / differential pressure transmitter DMG5 was developed for supervising overpressure of cleanrooms.
A differential pressure sensor range +/- 50 Pa, red LED-display, alarm-lamp, signal horn, analogue output 0-10 V and 4-20 mA for connection with data logger, 2 switching outputs with adjustable threshold value and an additional circuitry to store the alarm message at increasing pressure in the normal range after fall back of the threshold value of the switching output are included.
By using of a red button at the front its possible to reset the alarm message. A software controlled signal damping for display and switching outputs can selected by 10 steps.
Liquid Flow Switch
RCM general purpose Flo-Guard II flow switches (liquid) reed switches make or break contacts by detecting the position of a magnet permanently attached to the bellow. Our reed switches can also be ordered for use in hazardous location (Option IS), when fitted with LED's (Option LED) it provides viewing at a glance when flow rate goes below or above the set point and makes field calibration easy
Orifice Flowmeter
The RCM Flo-Gage is a direct reading flow meter with a large, easy to read dial calibrated in engineering units (GPM, SCFM, l/m, etc.) The Flo-Gage measures flow based on a pressure diffential created across a built-in calibrated nozzle. The meter is self-contained and complete, seperate orifices, or blocking, purging or equalizing valves
The Flo-Gage is suitable for measuring water, oil and most other low viscocity liquids which do not deposit out and which are compatible with the materials of construction. The Flo-Gage is also suitable for measuring compressed air, oxygen, carbon dioxide and many other non-toxic compressed gases. (Specify Option I). Saturated steam can also be measured up to 120 psig. (Option K).
Positive Displacement Flowmeter for Water (Elster Helix 4000)
Kent Elster Helix Woltmann cold water meter can be installed in horizontal, vertical or inclined pipelines without loss of accuracy. This meter not only conforms to relevant BS, ISO and EEC standards, but offers user benefits which greatly exceed these specifications.
Pressure Data Logger PR series
It is simple to use this Dickson pressure logger PR125, PR325, PR525, PR120, PR320 to record and integrate pressure data into documents and spreadsheets, giving results a professional, polished look. When fulfillment of regulatory requirements or accurate recording of pressure for quality control is needed, this logger is the perfect instrument.
Pressure Recorder PW4 PW8
Dickson Pressure Recorder PW4 and PW8 series comes with weather-resistant case-- the outdoor pressure monitoring solution of choice
SPI Magnetic Flowmeter
Electromagnetic flow meters detect flow by using Faraday's Law of induction.
Inside an electromagnetic flow meter, there is an electromagnetic coil that generates a magnetic field, and electrodes that capture electromotive force(voltage). Due to this, although it may appear as if there is nothing inside the flow pipe of an electromagnetic flow meter, flow can be measured.
SPI Oval Gear Flowmeter
Oval gear flowmeters are categorised as positive displacement flow technology. When liquid flows through this type of positive displacement flowmeter, two oval geared rotors measure a constant volume per rotation within a precisely machined measuring chamber.
With each rotation, a constant volume of liquid is measured. The rotation of the oval gears is sensed via magnets embedded within the rotors. These magnets transmit a high resolution pulse output. The output signal can be process externally via a remote display controller or PLC or via a variety of output/display options available as accessories attached to the flowmeters.
The positive displacement flow technology allows for precise flow measurement of most clean liquids regardless of the media conductivity. Other liquid properties also have a minimal effect on the performance of this type of meter. Flow profile conditioning is not required as with alternative flow technology options making oval gear installations simple to install in tight spaces and at an economical price.